Cyclades-PR4000

Example 2 Connection to an Internet Access Provider via Modem

This section will guide you through a complete router installation for the connection of a LAN to an Internet access provider via PPP. The configuration of NAT (Network Address Translation) will also be shown. Figure 4.6 shows the example system used in this section. Spaces have been provided next to the parameters needed for the configuration where you can fill in the parameters for your system. Do this now before continuing.

RS-232 _ _ _

 

PC

Network

DSU/CSU

 

192.168.0.0

 

Host

 

 

 

PR4000

Host

 

192.168.0.30 _ _ _ _ _ _ _ _ _

IP Address

 

192.168.0.11

 

 

 

 

Assigned

 

192.168.0.10 _ _ _ _ _ _ _ _ _

Dynamically

192.168.0.1_ _ _ _ _ _ _ _ _

 

 

 

FIGURE 4.6 CONNECTION TO ACCESS PROVIDER USING A SWAN INTERFACE AND A MODEM

Please read the entire example and follow the instructions before turning the router on. The router is programmed to log the super user off after 10 minutes of inactivity. All data not explicitly saved to memory is then lost. Collecting the data while configuring the router will likely cause delays and frustration.

Chapter 4 - Step-by-Step Instructions

37

Page 37
Image 37
Avocent Cyclades-PR4000 installation manual 192.168.0.0, PR4000 Host, 192.168.0.11, 192.168.0.10