Cyclades-PR4000

STEP TWO

No more parameters are necessary for the Ethernet interface. The other interface to be configured is the SWAN in slot 1. The SWAN physical media parameters are shown in Figure 4.8. Fill in the values for your application. The SWAN configuration is described in more detail in chapter 6 of the Installation Guide.

Menu CONFIG=>INTERFACE=>SWAN=>PHYSICAL

Parameter

Example

Your Application

Mode

Asynchronous

 

Speed

115.2k

 

FIGURE 4.8 SWAN PHYSICAL MENU PARAMETERS

STEP THREE

The network protocol parameters, shown in Figure 4.9, are similar to those for the Ethernet interface. Fill in the parameters for your network in the right-most column. For an example using NAT where the Primary IP Address is not dynamically assigned, see the chapter dedicated to NAT in the Installation Manual.

Menu CONFIG=>INTERFACE=>SWAN=>NETWORK PROTOCOL=>IP

Parameter

Example

Your Application

Active or Inactive

Active enables IP communication (IPX

 

 

and Transparent Bridge are not used in

 

 

this example).

 

Interface

Numbered

 

Unnumbered/

 

 

Numbered

 

 

Primary IP Address

0.0.0.0 (This number will be assigned

 

 

by the Access Provider dynamically.)

 

Subnet Mask

255.0.0.0

 

FIGURE 4.9 SWAN NETWORK PROTOCOL (IP) MENU PARAMETERS

Chapter 4 - Step-by-Step Instructions

39

Page 39
Image 39
Avocent Cyclades-PR4000 installation manual Swan Physical Menu Parameters