Avocent Cyclades-PR4000 installation manual Static Route Menu Parameters, Step SIX

Cyclades-PR4000

STEP FIVE

A static route must be added to tell the router that all traffic not intended for the local LAN should be sent to the Access Provider. Chapter 12 of the Installation Guide explains static routes and other routing methods available in CyROS. Fill in the spaces in Figure 4.11 with the values for your application.

Menu CONFIG=>STATIC ROUTES=>IP=>ADD ROUTE

Parameter	Example	Your Application
Destination IP	Type in the word "DEFAULT".
Address
Gateway or	Interface, because the IP addresses
Interface	are not known at configuration time.
Interface	Link 1 in the example.
Is This a Backup	No
Route?
OSPF Advertises	No
This Static Route

FIGURE 4.11 STATIC ROUTE MENU PARAMETERS

STEP SIX

NAT must now be activated. There are two varieties of NAT: Normal and Expanded. This example uses the Normal NAT Mode. The other mode is explained in the chapter on NAT in the Installation Manual.

Menu CONFIG =>SECURITY =>NAT =>GENERAL

Parameter	Example	Your Application
Nat Status	Enabled
Nat Mode	Normal
Disable Port Translation	No

FIGURE 4.12 GENERAL NAT PARAMETERS

Chapter 4 - Step-by-Step Instructions 42