Avocent Cyclades-PR4000 installation manual Step Ten, Step Eleven

Cyclades-PR4000

Step Ten:

Replace the PR4000’s cover and replace the screws. Now you can remove the wrist-strap.

Step Eleven:

Reconnect the PR4000’s cables, including the console cable. PR4000. Plug in the power cable and turn the PR4000 on. should appear (two boards are shown in this example):

Start up the terminal program used to access the When the PR4000 boots, the following messages

DSP Cards Detected . . . . . . . . . . . . OK 8-DSP CARD on DIMM 1

8-DSP CARD on DIMM 2

Loading modem 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16 . . . done

If there is a problem with the board or if the messages shown above (for the correct number of modems) do not appear, call Cyclades’ Technical Support.

The board should be connected to the PR4000 only by its presence in the slot. The terminals on the opposite side of the board are not intended to be used for a connection.

Appendix D - Installation of Additional Digital Modems 171