Port Control interface
Port Trunk
The Link Aggregation Control Protocol (LACP) provides a standardized method for exchanging information between Partner Systems on a link. This allows their Link Aggregation Control instances to reach an agreement on the identity of the Link Aggregation Group, move the link to that Link Aggregation Group, and enable its transmission and reception functions in an orderly manner. Link aggregation lets you group up to four consecutive ports into two dedicated connections. This feature expands bandwidth to a device on the network. LACP operation requires
Aggregator setting
1.System Priority: a value used to identify the active LACP. The switch with the lowest value has the highest priority. It is selected as the active LACP.
2.Group ID: There are four trunk groups available. Choose the "Group
ID" and click Select 
3.LACP: If enabled, the group is an LACP static trunk group. If disabled, the group is local static trunk group. All ports support LACP dynamic trunk. If connected to a device that also supports LACP, the LACP dynamic trunk group is automatically created.
4.Work ports: A maximum of four ports can be aggregated at the same time. With LACP static trunk group, any excess ports are considered standby and can be aggregated if a work port fails. If it is local static trunk group, the number of ports must be the same as the group member ports.
5. Select the ports to add to the trunk group. Click | Add | button to add |
|
|
|
the port. To remove unwanted ports, select | the | port and click |
|
| Remove | button. |
|
68 |
|
|
|
|
|
| Manual Documentation Number: | ||
|
|
| ||
|
| B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph | ||
|
| B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 | – Fax +353 | |
