Xerox 8510 manual Dynamic Methods of Setting the System’s IP Address, Enabling Dhcp on the System

Configuring the Network Address

Dynamic Methods of Setting the System’s IP Address

Set the system’s IP address using any of the following methods. DHCP is enabled by default on all Phaser printers.

■DHCP

■CentreWare IS

■AutoIP

Information Required for Manual IP Addressing

Information	Comments
Internet Protocol (IP) address of the system	Format is xxx.xxx.xxx.xxx, where xxx represents
	a decimal number from 0–255.
Network Mask	If you are unsure, leave this blank; the system
	chooses an appropriate mask.
Default Router/Gateway address	Router address is required to communicate with
	the host device from anywhere other than the
	local network segment.

Enabling DHCP on the System

Verify that the system DHCP protocol is enabled by setting the control panel or by using CentreWare IS. DHCP is enabled by default.

Note: To determine the system’s IP address, select System Identification. On the control panel, press the System button, select Information, press the OK button, select System Identification, and then press the OK button to view the system’s IP address.

See also:

Control Panel Features on page 1-8

Phaser® 8510/8560MFP Multifunction Product

2-6