Configuring the Network Address
Manually Setting the System’s IP Address
Note: Verify that your computer has a properly configured IP address for your network. Contact your network administrator for more information.
If you are on a network without a DNS server, or in an environment where the network administrator assigns system IP addresses, you can use this method to manually set the IP address. Manually setting the IP address overrides DHCP and AutoIP. Alternatively, if you are in a small office with a single PC and use a dialup modem connection, you can manually set the IP address.
1.On the control panel, press the System button.
2.Select Connection Setup, and then press the OK button.
3.Select Network Setup, and then press the OK button.
4.Select TCP/IP Setup, and then press the OK button.
5.Select DHCP/BOOTP, select Off, and then press the OK button.
6.Select TCP/IP Address, and then press the OK button.
7.Enter the system’s IP address, and then press the OK button.
See also:
Advanced Features Guide at www.xerox.com/office/8510_8560support
Phaser® 8510/8560MFP Multifunction Product
