Adjusting Copying Options

Using the Prescan Glass Option

When using the document glass, you can prescan originals when using the auto center, edge erase, auto reduce/enlarge, and poster options.

To select a prescan setting:

1.On the control panel, press the Copy button.

2.Select Prescan Glass, and then press the OK button.

3.Select one of the following options:

Off: Turns off prescanning. Select an original size for your copy.

On: Turns on prescanning when any of the auto center, edge erase, auto reduce/enlarge, and poster options are turned on. When all these options are turned off, the copy area is calculated based on the current paper supply size.

Note: The book copy option always prescans.

See also:

Selecting an Original Size on page 4-8

Reducing or Enlarging the Image

You can reduce the image to 25% of its original size or enlarge it to 400% of its original size.

To use reduce or enlarge the image:

1.On the control panel, press the Copy button.

2.Select one of the following options:

Select Preset Reduce/Enlarge, and then press the OK button. A list of preset values appears from which you can select the size of the original followed by the size of the copy paper.

Press the Reduce/Enlarge cascade button on the control panel to select these options:

Auto: Reduces or enlarges the image as needed to fit the full size of the copy paper.

25%-400%: Reduces or enlarges the image by a selected percentage: 25, 50, 100, 150, 200, and 400.

Press the up or down button below the three-digit LED to reduce or enlarge the copy size in increments of one percent. 100% keeps the copy image the same size as the original.

Note: The factory default is 100%.

Phaser® 8510/8560MFP Multifunction Product

4-9

Page 102
Image 102
Xerox 8510 manual Using the Prescan Glass Option, Reducing or Enlarging the Image