|
|
| Technical information |
| Table | ||
|
|
|
|
| Reliable feeds may be | Less reliable feeds may be |
|
Stock | expected | expected | Suggested alternatives |
|
|
|
|
Weight | Substance 16 to 110 (60 to |
| Weights outside the limits |
| 200 g/m2) |
| shown are not |
| Substance 110 (200 g/m2) |
| recommended. |
|
|
| |
| must be long grain. |
|
|
|
|
|
|
Type or | Xerographic bond paper in | Slightly curled paper | Do not use excessively |
condition | good condition | Paper with reinforced edges | curled paper |
|
|
| |
| Drilled stock, fanned |
| Refer to the “Using various |
| thoroughly |
| stocks” section for any stock |
|
|
| not defined in this guide. |
|
|
|
|
Using various stocks
The following table lists stock that have been evaluated and tested for use in this system. There are many other stocks available, some of which may not provide the same degree of user satisfaction. Refer to the “Using
Table 7-10. Satisfaction guide for various stocks
Stock type | Instructions for use | |
|
| |
Substance 13 (49 g/m2) | Use trays 3,4,or 5. | |
paper | Do not run | |
| ||
| Load the paper with seam side down into tray 3. | |
| Optimum satisfaction can be expected with 8.5 x | |
| 11 inch (216 x 279 mm) or larger paper. | |
|
| |
Substance 16 (60 g/m2) | Load paper with seam side up into trays 1 and 2; | |
paper | seam side down into tray 3, 4, or 5. | |
| Optimum satisfaction can be expected from tray | |
| 3, 4, or 5. | |
|
| |
Substance 20 (75 g/m2) | Load the paper with seam side up into trays 1 | |
paper | and 2; seam side down into trays 3, 4, and 5. | |
|
| |
Card stock | Card stock can be run from any tray. | |
Xerox substance 65 (176 | Reduce set size if frequent paper jams or | |
g/m2) | bindexer jams occur. If collated unfinished, | |
Substance 110 (200 g/m2) | another solution is to lower the value of the | |
bindexer capacity set in the SWITCHES mode. | ||
long grain (index) | ||
| ||
|
|
DocuTech 61xx Operator Guide |