Routine maintenance

Adjusting the decurler lever

Perform the following steps to adjust the decurler lever.

CAUTION

Do not use any paper that is not suitable for system use.

1.Open the right door of the processor.

2.Locate the decurler lever in area 7 of the paper path, as shown in figure 5-46.

Figure 5-46. Locating the decurler lever

3.If the print curl is +2 or more, move the green decurler lever to the right.

4.If the print curl is -3 or more, move the green decurler lever to the left.

5.If the decurler adjustment does not eliminate the paper curl problem, or for other curl problems, turn the stack of paper over in the paper tray.

6.If there is still a curl problem, perform steps 1 to 4 again.

NOTE: A final solution to the curl problem may be to load a new ream of paper.

7.Close the processor door.

5-46

DocuTech 61xx Operator Guide

Page 88
Image 88
Xerox 61xx manual Adjusting the decurler lever, Locating the decurler lever