Xerox 61xx manual Preparing the paper tray

Routine maintenance

Figure 5-1. Preparing the paper tray

NOTE: To load the paper correctly, refer to the label located on the inside panel at the front of the paper tray. Remove any damaged sheets from the top of the stack.

CAUTION

Do not load the paper above the red line. A jam could occur if too much paper is loaded in the tray.

6.Load the required paper into the paper tray. Load paper with the curl side facing down. Load Xerox paper with the package wrapper seam side facing up.

NOTE: When loading drilled paper, be sure to fan the edge where the holes are located.

7.Position the stack against the front right corner of the tray, as shown in figure 5-2. This is indicated by the green arrow on the bottom of the tray.

5-2 DocuTech 61xx Operator Guide