Xerox 61xx manual 10. Satisfaction guide for various stocks

Technical information

Table 7-10. Satisfaction guide for various stocks

Stock type	Instructions for use
Preprinted stock	Preprinted forms must be made up of ink that has
	the following characteristics:
	• Can withstand temperatures up to 400°F
	(204°C)
	• Can withstand pressure of 140 psi at the
	above temperature
	• Can withstand the above conditions for 25
	milliseconds
High speed	Load the stock with the stripe to the right in trays
transparencies with white	1 and 2.
stripe
Label stock	Load the stock face up into trays 1 and 2; face
	down into trays 3, 4, and 5.
	Do not select 2-sided prints.
Letterhead (preprinted)	Load the paper into trays 3, 4, and 5; side 1 with
	the printed side down, top edge to the front of the
	tray.
	Load the paper into trays 1 and 2; side 1 up with
	the top edge to the front of the tray.
	Do not use freshly preprinted paper in trays 1 and
	2.
Textured paper	Heavily textured paper may produce prints with a
	ragged character appearance or deletions. To
	test, run a proof print.
Window stock	Run if the window is 2.2 to 4 inches (57 to 102
	mm) from the top edge of the paper and at least 1
	inch (25.4 mm) from each side of the paper.
	Run only as the first page or a front cover to
	avoid finisher bin jams.
	Load the window stock face-up into a tray (tray 1
	or 2 is recommended) with the top edge toward
	the front of the tray.
	If running plastic-covered window stock, there
	may be some distortion. To test, run a proof copy.
Xerox Carbonless	Xerox Carbonless Paper is recommended.

Do not use the following stocks:

•Multipart forms

•Stocks outside of the recommended size and weight ranges

DocuTech 61xx Operator Guide 7-13