Problem solving
WARNING
The fuser roll is approximately 425°F (218°C). Do not touch the fuser roll when performing this procedure or you may get burned.
1.Open the processor doors.
2.Open the fuser drawer.
a.Grasp the green handle on the fuser drawer, as shown in figure
b.Pull the fuser drawer out until it stops.
Figure 6-18. Opening the fuser drawer
WARNING
There are moving parts in the fuser drawer. To avoid injury, touch only the brake release when performing this procedure.
3.Locate the camming motor on the back of the fuser drawer, as shown in figure
4.Locate the camming motor brake release under the camming motor, as shown in figure
5.Push and hold the brake release in an upward position. The camming motor will begin to run slowly.
DocuTech 61xx Operator Guide |
