Problem solving

Figure 6-8. Q1009 sensor location

3.Clean the sensor and mirror:

a.Apply a small amount of lens and mirror cleaner to a cleaning pad.

b.Wipe the sensor and mirror gently with the cleaning pad.

4.Close the processor doors.

Clearing or cleaning the finisher sensors

Clearing the finisher sensors should be performed only when directed by a Customer Support Center Representative.

NOTE: The finisher sensors are located under the processor top cover, under the finisher top cover, and behind the finisher and bindexer doors.

Use the following procedure to clear any obstructions from the finisher sensors.

Perform the following when it is necessary to clean the finisher sensors.

1.Fold a sheet of 8.5 x 11 inch (216 x 279 mm) paper, as shown in figure 6-9.

DocuTech 61xx Operator Guide

6-17

Page 105
Image 105
Xerox 61xx manual Q1009 sensor location, Clearing or cleaning the finisher sensors