Problem solving
| Table | |
|
| |
Binder tape is too long | Adjust the binder tape length using the procedure entitled "Adjusting the | |
or too short on the | binder tape registration" in the "Routine maintenance" chapter. | |
bottom edge of the | If an adjustment is made to the binder tape length during a job, it will not | |
output prints | ||
take effect until the next job is printed. If it is necessary to adjust the binder | ||
| ||
| tape length during a job, adjust it using the procedures in the | |
|
| |
Loose binder tape | This is a symptom of excessive moisture in the tape. Replace the tape reel | |
along the spine of the | with a new reel using the procedure, "Replacing the binder tape reel," in | |
completed bound | the "Routine maintenance" chapter. | |
book | Refer to the binder tape storage guidelines in this guide. | |
| ||
|
| |
Repeated tape | If the binder tape is sticking together, or if there are cosmetic defects in the | |
feeding problems, | bound book, replace the tape reel with a new reel using the procedure, | |
such as binder tape | "Replacing the binder tape reel," in the "Routine maintenance" chapter. | |
not unwinding from | Refer to the binder tape storage information in this guide. | |
the reel | ||
| ||
| Refer to the binder cleaning information in this guide. | |
| Refer to information on calling the Customer Support Center in this guide. | |
|
| |
Stitcher fault codes | Select the [Finishing] button on the Printer Manager window. Deselect | |
displayed in the fault | [Stitcher] on the Finishing window and refer to the procedure, "Calling for | |
frame | assistance," in this guide. | |
Fault Code | Stitcher A problems. Perform the procedure, "Clearing a stitcher spool A | |
Fault Code | fault," in this guide. | |
| ||
| Stitcher B problems. Refer to information on calling the Customer Support | |
| Center in this guide. | |
|
| |
Poor stitch quality or | Reliable stitching can be expected with up to 65 sheets of substance 20 | |
short stitches | (75 g/m2) or 0.28 inch (7 mm) thick sets. Less reliable stitching can be | |
| expected with over 70 sheets of substance 20 (75 g/m2). | |
| Running intermixed stock heavier than substance 20 (75 g/m2) will reduce | |
| the capacity of the stitcher. | |
| To avoid short clinches, use the stitch override only when using a | |
| lightweight paper. Stitch override allows the system to run beyond the | |
| stitching limit. The system will shut down at 125 sheets. | |
| Reduce the stock weight to enable the stitching of more sheets per set. | |
| Refer to the satisfaction guides in the "Technical information" chapter. | |
|
|
DocuTech 61xx Operator Guide |