Routine maintenance
The system uses stitcher wire from two spools located below the stacker. Stitcher spool A is used for portrait, top corner stitches. When stitcher spool A is empty, it must be replaced with a new stitcher spool. Stitcher spool B is used for portrait dual stitches and landscape stitches.
To replace stitcher spool B, if you have not been trained in eXcellerate, contact the Customer Support Center; refer to the section, “Calling for assistance”, in this guide.
To replace stitcher spool A, refer to the section, “Replacing the stitcher spool A”, in this guide.
The system applies binder tape from a reel mounted in the binder drawer in the finisher. You will need to replace the binder tape periodically.
WARNING
During operation, the binder heats the tape to 425°F (218°C). To avoid injury, use special care when you remove or replace the binder tape.
For information on cleaning the processor sensors, the reflecting surfaces, and the finisher sensors, refer to the appropriate sections in this booklet.
Precautions you should take
For your own safety and to protect the system, it is important to take the following precautions whenever you perform cleaning and replacement tasks.
•Use only the cleaning and replacement supplies that are approved or recommended by Xerox. If you use other supplies, you may damage the system.
•Keep supplies in stock as listed in the section, “Supplies to keep in stock”, in this guide.
•Whenever you use or remove a part from the system, handle the part carefully. Note any informative labels on the system.
•Keep atomized and aerosol sprays away from the system.
•Pour cleaning liquids onto a cloth. Do not pour or spray liquids directly onto system parts.
•Before reinstalling a system part that has been cleaned with a liquid, ensure that the part is dry.
DocuTech 61xx Operator Guide |
