4.0 Operating guide
Turn 4071 on. After a display of the hardware and software versions and serial number, the unit enters the Basic Sinewave mode of operation. The 4071 defaults to generating a 1.0 MHz sinewave at a level of
4.1 Changing frequency
To change the frequency, press the Right Field Arrow button once. The cursor will move to the frequency field. A flashing digit indicates the cursor position.
You can change the frequency two different ways. You can enter a new value or you can modify the current value. To enter a new value, type in the frequency using the numeric keypad. Then press the MHz key for MHz, or the KHz key for KHz, or the Hz key for Hz. The unit will make a two beeps sound to indicate that a new frequency value has been accepted.
To modify an existing value, use the è and ç keys to position the cursor over the digit you wish to change. Then press the é or ê key to increment or decrement that digit. Alternatively, you can turn the rotary knob clockwise or counterclockwise to adjust the digit's value.
4.2 Changing level
To set a new output level, press the Right Field Arrow button until the cursor flashes on the right hand side where the level is displayed. You can change the level two ways. You can type in a new value or adjust it with the wheel or arrow keys. To enter a new level, type in the new level value using the numeric keypad. For a negative dBm value, press the - key while entering the value. Finally, press the dBm key to enter the value as dBm or the
NOTE: The level you're entering here is considered a loaded level, i.e. the level that will appear across a 50O load connected to the output.
To modify an existing level value, use the è and ç keys to position the cursor within a field. Place the cursor over the digit you wish to change and press the é or ê key to increment or decrement the digit. Alternatively, you can turn the rotary knob clockwise or counterclockwise to adjust the digit's value.
4.3 Changing operating modes
To select another operating mode, press the red Mode key once. When pressed, the LCD display is cleared and the question Mode? is displayed. The Mode key acts as a shift type key in that the meaning of each button on the front panel changes to that described by the blue wording beneath it. To enter the SWEEP mode, for example, first press the Mode key and then press the number 4 key.
You can then use the Field Arrow keys to move the cursor to the parameter you wish to change. Each numeric value can be entered or modified in the same manner described above. This manual contains a separate chapter for each mode, which describes in detail all parameters on the LCD display. User could switch to other generating modes by pressing One Touch Mode Selection key or “Mode” key for more options.
4.4 Operating mode selection.
If you wish to select a new operating mode for the 4071, press the red Mode key once. When pressed, the LCD display is cleared and the question Mode? is displayed. The Mode key acts as a shift type key in that the meaning of each button on the front panel changes to that described by the red wording beneath it. To enter Sweep mode, for example, first press the Mode key and then press the number 4 key.
You can exit this question either by pressing the blue Mode key again or by pressing any key that does not have red text beneath it. The 4071 will then return to the current mode unchanged.
Some modes are available on the 4071 that are not printed on the front panel. To access these modes, press the Mode key, and then the key labeled "Other" (Clear key) to bring up a scroll menu, which displays the additional modes. You can scroll through the list with the arrow keys or the wheel. To select one of these modes, enter its menu number. User could switch to other generating modes by pressing One Touch Mode Selection key or “Mode” key for more options.
11
BK Precision 4071 User Manual Rev.2.2
