Barco R9000740 owner manual ADJ. adjust key, to enter or exit the adjustment mode

LOCATION AND FUNCTION OF CONTROLS

	LOCATION AND FUNCTION OF CONTROLS
	Back light key : when activated, all keys will be lit up and visible in the dark.
1
	ADJ. : adjust key, to enter or exit the adjustment mode.
2	Address key (sunk key), to enter the address of the projector (between
	0 and 9). Press the address key, followed by pressing one digit button
3
	between 0 and 9.
	STBY : stand by button : - to initiate remote power up operation
4
	- to stop projection without main power off.
	Pause :to blank the image, press PAUSE. The image disappears but full
5
	power is retained for immediate restarting.
	Digit buttons : direct input selection.
6
	Picture controls : use these buttons to obtain the desired level (see also
7
	'Controlling') for each picture function.
	TEXT : when adjusting one of the image controls during a meeting, the
8
	displayed bar scale can be removed by pressing 'TEXT' key first. To re	-
	display the bar scale on the screen, press 'TEXT' key again. 'TEXT'	key
	is only active in operational mode. When 'TEXT' is off, no warning
	message will be displayed.
	ENTER : to start up the adjustment mode or to confirm an adjustment or
9
	selection in the adjustment mode.
	EXIT : to leave the adjustment mode or to scroll upwards when in the
10
	adjustment mode.
	Control disk : to make menu selections when in the adjustment mode.
11
	Also allows to increment or decrement an adjustment in the adjustment
	mode.
	control disk up = up arrow in the menus
	control disk down = down arrow in the menus
	control disk to the right = arrow to the right on the menus
	control disk to the left = arrow to the left on the menus
	RC operating indication : lights up when a button on the remote control
12
	is pressed. (This is a visual indicator to check the operation of the remote
	control)

2-6 R5975238 BARCOVISION 701 MULTIMEDIA 070497