Barco R9000740 owner manual How to program an address into the RCU?

CONTROLLING

CONTROLLING

How to program an address into the RCU?

Press the ADDRESS key (recessed key on the RCU) with a pencil and enter the address with the digit buttons. That address can be any digit between 0 and 9. When programming '0', zero address, the RCU will control a projector regardless of the projector's address. This feature allows multiple projectors with different addresses to be controlled by a single RCU.

Input selection

Source No	Projector input	Press digit button
1	Comp. Video	1
2	S-Video	2
3	RGBS or RGsB	3
4	RGB3S or RG3sB	4
5	(R-Y)Y(B-Y)S or
	(R-Y)Ys(B-Y)	5
6	(R-Y)Y(B-Y)3S or
	(R-Y)Y3s(B-Y)	6

Two possible ways of selecting an input :

a)With the digit buttons on the RCU, it is possible to select one of the four input sources, Video, S-Video, RGsB or RGBS, RG3sB or RGB3S, (R-Y)Ys(B-Y) or (R-Y)Y(B-Y)S, (R-Y)Y3s(B-Y) or (R-Y)Y(B-Y)3S.

b)With the local keypad :

press first the ADJUST key to display the

General access menu.

A D TE X I T

S TAN D B YE NTE R

5-6 R5975238 BARCOVISION 701 MULTIMEDIA 070497