SERVICE MODE
The 'Identification' screen gives in- formation concerning :
-Projector address. To change the address of your projector, contact a qualified service technician.
-Software version.
-Configuration.
Possible installations :
*
*
*
*
V 701 MULTIM EDI A
P ro j . a d dr e s s : 00 1
S of t . V er si on : 5 . 0 0
C on f ig . : C ei l in g front
B a u d r a t e P C : 9 6 0 0
T e x t : O N
S e r i al N o . : 1 03 5 9 8 5 2
- Baud rate PC : transfer speed for communication with an IBM PC (or compat- ible) or MAC. The baud rate of the projector must be the same as the baud rate of the connected computer. When there is a difference, contact a qualified service technician to make the appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator will be displayed and if warnings and failures will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on the RCU.
-Serial no. : indicates the fabrication number of the projector. This number can be useful when calling for technical assistance.
Total Run Time
Highlight 'Total Run Time' with the control disk and press ENTER to display the amount of time the pro- jector has played since its first start up at the factory.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS 
CHANGE BAUDRATE 
POWER UP MODE : operating 
BARCO LOGO
Select with 
or
then <ENTER>
<EXIT> to return.
MODE
ENTER gives the selected item.
EXIT returns to the Service mode menu. ADJUST returns to the Operational mode.
SERVICE
R5975228 BARCOVISION 701 MULTIMEDIA 070597 |
| |
|
