Behringer MX9000 user manual Aux sends post EQ, MIX-B source post fader, LED meters pre fader

24.1 Aux sends > post EQ

All channel aux sends are post mute and pre fader. If you want to convert these to post EQ, carry out the following modification to each channel. You will find a corresponding printing on the PCB (see fig. 24.1).

1.Disconnect power supply.

2.Cut the “post mute” track.

3.Add in a “post EQ” link.

4.Repeat for all channels you want to be modified.

Fig. 24.1: Modifications aux send > post EQ

24.2 MIX-B source > post fader

That's it. You've decided to use the MIX-B as a stereo aux send to FX rather than a separate stereo feed. You can move the tap from the A-channel from pre to post the channel fader as follows. Again, look for the printing on the PCB shown below.

1.Disconnect power supply.

2.Cut the “pre” track.

3.Add in a “post” link.

4.Repeat for all channels you want to be modified.

Fig. 24.2: Modifications MIX-B source > post fader

24.3 LED meters > pre fader

In channel mode the meterbridge monitors the DIRECT OUT signal (post EQ, post mute and post fader). You would prefer to see what's going on pre mute and pre fader? Once you found the corresponding printing on the PCB, all you have do is:

1.Disconnect power supply.

2.Cut the “line out” track.

3.Add in a “pre fade” link.

4.Repeat for all channels you want to be modified.

Fig. 24.3: Modifications LED meters > pre fader

51