English
5.Lift the handle so that it stands up. Use the handle to slowly pull the lamp out of the projector.
•Pulling it too quickly may cause the lamp to break and scatter broken glass in the projector. To reduce the risk of injuries to fingers and damage to internal components, use caution when removing lamp glass that has shattered.
•Do not place the lamp in locations where water might splash on it, children can reach it, near or above heat sources, or near flammable materials.
•Do not insert your hand into the projector when the lamp is removed. If you touch the optical components inside, it could cause blurred images.
6.As shown in the figure, lower the new lamp first into the connector on the projector and align the two holes on the lamp with the locators on the projector.
7.Push the lamp downwards to ensure it is firmly secured to the projector.
8.Tighten the screws securing the lamp box.
9.
10. Tighten the screw on the lamp cover.
• Please be careful to not
• Loose screws may cause a bad connection, which could result in malfunction.
11. Turn the power on and reset the lamp time. | WARNING | |
i. Press MENU to open the OSD menu. | ||
|
ii.Go to the Advanced Setup > Lamp Settings menu and press ENTER.
iii.Highlight Reset Lamp Timer and press ENTER.
iv.A warning message displays asking if you want to reset the lamp timer.
v.Highlight Reset and press ENTER to reset the lamp timer to "0".
Reset Lamp Timer?
Reset Cancel
Do not reset the lamp timer if the lamp has not been replaced as this could cause damage.
46 Maintenance
