BIXOLON SRP-270 service manual Remove method by manual

SRP-270

8-2-2-2 Precautions on Paper Insertion

1)After cutting the edge of paper straight as shown in figure insert the paper. Which is described on next figure.

2)Insert the paper straight into the paper entrance section.

3)The end of the paper which is crinkled and bended, should not be inserted.

4)Make sure that the rolled paper tape is ripped off and discarded before inserting into the printer.

8-2-2-3 Precautions on paper removal

Cut the paper behind Bas e Paper Feed Assy.

8-2-2-4 Paper removal must be performed using one of the four method below

*Remove method by manual

1)Back feed the paper by rotating Gear Knob to contrary arrow direction manually and remove the paper.

2)After Feed the paper by rotating Gear Knob to arrow direction cutting paper in backside Base Paper Feed Assy, and remove the paper.

*Remove method by automatically

1)Back feed the paper by using electrical operation (by paper back-feed button), then remove the paper.

2)After cutting paper in backside paper guide Assy, feed the paper by using electrical operation (by paper back feed button), then remove the paper.

※NOTE: Never perform paper removal without carefully following the above precautions , because such handling may result in defective paper feeding or paper Jams.

Rev. 3.02 - 63 -