Rev. 3.02 - 84 -
SRP-270
8-8-2-8 Main assembling - #5
Name of Parts Method and Procedure
①RIBBON FRAME
②SPRING RIBBON FRAME
③E-RING (ø3, 3EA)
1. Insert ⓐSPRING RIBBON FRAME into the hole in left side of
ⓑRIBBON FRAME to ward arrow on shows in Fig. 1 detail.
2. Set SPRING RIBBON FRAME ⓐonto the SHAFTⓒ and then, move
the RIBBON FRAME toward arrow.
3. Next, insert RIBBON FRAME onto SHAFTⓓ toward arrow an shows in
Fig. 3.
4. And then, insert the other hole A of RIBBON FRAME onto SHAFT ⓒ
and then, adjust the position of RIBBON FRAME to the center as
shows in Fig. 4.
5. Firs t E-RING to SHAFT ⓒand two E-RING to SHAFTⓓ.
6. Check RIBBON FRAME to move smoothly as operating it up and
down.