SRP-270
2-2 Operation
2-2-1 Setting the DIP switches
The DIP switches are located on the bottom of the printer. The DIP switches are used to set the printer to perform various functions. Follow these when changing DIP switches setting :
1. Turn the printer power switch off.
2. Remove the screw on the bottom of the printer and open the bracket.
3. Flip the DIP switches using tweezers or another narrow- ended tool. Switches are on when up and off when off down.
4. The new setting takes effect when you turn on the printer.
※ Note : Always change DIP switch settings only when the printer is turned off. Change made with the power on have no effect and then on again.
2-2-2 Setting the DIP switch (RS-232C Serial Interface)
• DIP Switch 1
SW |
|
| FUNCTION |
| ON | OFF |
| DEFAULT |
1 |
|
| Emulation Selection |
| Refer to the following Table 1 |
| OFF | |
2 |
|
|
|
| OFF | |||
|
|
|
|
|
|
| ||
3 |
|
|
| Enable | Disable |
| OFF | |
4 |
|
| FONT SPACE | 2 | 3 |
| OFF | |
5 |
|
| Function for Service Engineer |
|
|
| - | |
6 |
|
|
|
|
| - | ||
7 |
|
|
|
|
|
|
| OFF |
8 |
|
| Korean Type Selection |
| Unified | Complete |
| OFF |
• DIP Switch 2 |
|
|
|
| OFF | |
SW |
|
| FUNCTION |
| ON | |
1 |
|
| Auto Line Feed |
| Always | Always |
|
|
| Enabled | Disabled | ||
|
|
|
|
| ||
2 |
|
| Hexadecimal dump |
| YES | NO |
3 |
|
| Hand Shaking |
| XON/OFF | DTR/DSR |
4 |
|
| Word length |
| 7 bits | 8 bits |
5 |
|
| Parity check |
| Enable | Disable |
6 |
|
| Parity selection |
| EVEN | ODD |
7 |
|
| Baud Rate selection |
| Refer to the following Table 2 | |
8 |
|
|
| |||
|
|
|
|
|
| |
DEFAULT
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
※NOTE
When the word length is 7 bits, you can not parity check OFF status.
Rev. 3.02 | - 11 - |
