Black Box 24 port, 16 port manual CLI commands, Add community, Add DNS, Inetaddress, 142

CLI commands

add community

user level: This command enables you to define up to four SNMP communities. admin

Syntax add community community_name inetaddress

none readonly readwrite

Where:

community_name is an arbitrary name assigned to the community.

inetaddress is the internet address that identifies the host(s) in the community.

none readonly defines the access permission for the community. readwrite

See also

add trap, delete community, set contact, set location, show snmp

add DNS

user level: This command enables you to define the DNS (Domain Name Service) host or hosts

admin in your network. You can enter the addresses two DNS hosts in the unit; one will be referred to as the primary host, the other a secondary host. The DNS hosts do not have to be the same hosts as entered in your unit’s host table.

On a remote access connection the unit will transmit these addresses to a dial-up Windows NT/95 client. Therefore, your remote user does not have to configure DNS parameters in his/her computer.

For more information on DNS see DNS configuration on page 56.

Syntax add DNS internet_address

Note ‘DNS’ must be entered in upper case. Also:

internet address is the internet address of your machine providing the DNS; enter the address in dot decimal notation.

Black Box Console Server user guide 142