Black Box 24 port, 16 port manual Selecting AUI or 10/100 Base T interface, 10/100Base-T

Selecting AUI or 10/100 Base T interface

Before performing the initial configuration of your Console Server unit, you need to select the type of interface you want to use from either AUI or 10/100Base-T (Default setting is 10/100Base-T). To do this proceed as follows;

Note To display the currently selected interface type, at the command prompt, type show hardware and press the Enter key. The resulting display will include the currently selected hardware type.

You only need to use these commands on revision 2 Console Server boards.

1.Login to your unit and display the command prompt.

2.At the command prompt, type one of the commands listed in the next table to select the interface type you want to use.

To set this type of interface	Use this command
10/100Base-T	set	ethernet	interface RJ45
AUI	set	ethernet	interface AUI

You can now perform the initial configuration of the unit.

Black Box Console Server user guide 32