Black Box 24 port, 16 port manual 102

TCP Port No(ignore this field unless you have selected a user Service of ‘telnet’)

(telnet only) enter the TCP/IP port number of the host with which the unit should start the telnet service. The default port is 23; in most cases you should leave the value at default.

phone	Enter a telephone number for the unit to call back the user; do not use spaces. You
number	must also have ‘callback’ set to on. (The number you enter is unrelated to the
	‘phone_number’ or ‘dial’ parameters you can set for a line).
idle timer	(you may wish to change this setting for terminal server connections) enter a period
	in seconds for which the idle timer will run. Use this timer to close a connection
	because of user inactivity. When the idle timer expires the unit will end the
	connection. The default value is 300 seconds, meaning the idle timer will expire 300
	seconds after the last activity. The maximum value is 4294967 seconds (equal to 49
	days, approximately). A value of 0 (zero) means the idle timer will not expire so the
	connection is open permanently.
	Note: this idle timer will override the idle timer which you can configure for a line.

session timer (you may wish to change this setting for terminal server connections) enter a period in seconds for which the session timer will run. Use this timer to forcibly close a user’s session (connection). When the session timer expires the unit will end the connection. The default value is 0 (zero), meaning that the session timer will not expire (the session is open permanently, or until the user logs out). The maximum value is 4294967 seconds (equal to 49 days, approximately).

Note: this session timer will override the session timer which you can configure for a line.

Level	This field cycles through ‘admin’, ‘normal’ and ‘restricted’. These are privilege
	levels and are described in Configuring a dial in line on page 74. The ‘admin’ user
	(i.e. you as system administrator) always has ‘admin’ level account (maximum
	privileges).
IP Host	(ignore this field unless you have selected a user service of ‘telnet’ or ‘rlogin’ or
	‘tcp clear’).
	0.0.0.0 - default. The unit will use the default ip host configured for all users
	who login to the unit. The default ip host is set in the ‘server configuration’
	menu; see Console Server, (or in the cli see command ‘set server’). The IP
	address entered here does not affect the host table or any line configuration.

Black Box Console Server user guide 102