Blaupunkt MP56 7 646 583 310 Changing the volume presetting of the telephone Phone

Changing basic settings in the settings menu

Changing the volume presetting of the telephone (PHONE)

If the device puts a phone call through, it always starts at the preset volume.

➔Press the softkey 8 (next to "PHONE").

The "PHONE" menu item is

flashing. The presetting for the telephone volume is shown on the main line A.

➔Adjust the desired volume us- ing the volume control 5 or the rocker switch 3 (incre- ments 1 to 50).

During the phone call, you can always change the volume by means of the volume control 5.

Changing the volume presetting of the signal tone (BEEP)

If a signal tone sounds, you al- ways hear it at the preset volume.

➔Press the softkey 9 (next to "BEEP").

The "BEEP" menu item is flash- ing. The presetting for the sig- nal tone is shown on the main line A.

➔Adjust the desired volume us- ing the volume control 5 or the rocker switch 3 (incre- ments 0 to 6).

You hear a signal tone at the se- lected volume.

➔If you do not want to hear any signal tones, set the volume to zero.

"BEEP OFF" appears on the main line A.

Changing the presetting of the power-on volume (ON VOL)

You can configure the device so that the playback after switch-on always starts with the volume set here. For this purpose, the "ON VOL" menu item must be high- lighted.

➔Press the softkey < (next to "ON VOL").

The presetting for the pow- er-on volume is shown on the main line A.

➔Adjust the desired volume us- ing the volume control 5 or the rocker switch 3 (incre- ments 1 to 50).

The "ON VOL" menu item is highlighted.

Restoring the volume at switch- on (LAST VOL)

You can configure the device so that the playback after switch-on always starts with the previous- ly selected volume. For this pur- pose, the "LAST VOL" menu item must be highlighted.

116