Tape operation
Switching Dolby B NR on/off:
•press DLBY.
*The noise reduction system manufactured under li- cence from the Dolby Laboratories Licensing Corpo- ration. The word DOLBY and the
Selecting the display mode
You can switch the display mode during tape deck operation to display the tape side or the clock.
•Press DIS briefly.
Either the tape counter or Side A/B will ap- pear in the DOT display.
Track reverse
To change the track during playback:
Scanning cassette titles with
SCAN
It is possible to scan the titles on a cassette. As soon as you find a title you like, you can end SCAN. This title will then continue to play.
SCAN is active when the corresponding red arrow flashes in the display.
To start/end SCAN:
•Press SCAN.
Selecting titles with S-CPS
(Super Cassette Program Search)
To repeat and skip cassette titles.
/
Select title
Forward
Rewind
It is possible to skip up to 9 titles. To do so,
•press 
/
on the rocker switch as of- ten as required.
The number of titles to be skipped will ap-
DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS
•Press REV.
When the tape reaches the end of a side it
will automatically switch to the other side The scan time is set to 10 seconds at the (autoreverse). “SIDE A” will appear in the factory and can be altered from 5 to 30 sec- display for track 1 and “SIDE B” for track 2. onds.
pear in the display.
Make any corrections by pressing the op- posite key (
/
).
Press REV to stop this function immediate- ly.
SVENSKA
Note:
If there is too much tension on the tape while it is playing, it may switch to the opposite track before it has reached the end. Check to see if the tape is wound correctly. It often helps to rewind the cassette completely.
If necessary, refer to the section on “DSC To ensure that this function works properly,
programming - VAR (various), SCAN”. there must be a pause of at least 3 seconds between titles.
ESPAÑOL PORTUGUÊS
79
