Blaupunkt RCM 169 Switching the equalizer on/off, Self-adjusting equalizer, Hi-fi self-adjustment

To start the hi-fiself-adjustment, activate the DSA menu.

To take the reading hold the microphone in the corresponding position.

For EQ1 (driver alone), hold the microphone directly where the driver’s head would be. For EQ2 (driver and front-seat passenger), hold the microphone between the driver and front passenger seat and for EQ3, hold the microphone directly in the centre of the ve- hicle (left/right, front/rear).

These readings must be taken in a quiet area. Outside noise will distort the results. Make sure that nothing impedes the sound being emitted from the speakers. The mi- crophone must be connected to the car ster- eo system.

DSA – Digital Sound Adjustment

refer to the section on “Self-adjusting equal- EQ 3	for passengers in the front and
izer” or “Manual equalizer adjustment”.	back

The settings for “Rock to Vocal” are fixed values which cannot be adjusted.

• Press / to select the desired set- ting.

Switching the equalizer on/off

• To switch the equalizer off, press <<. “EQ off” will appear in the top line of the dis- play.

• To switch the equalizer on, press >>.

Self-adjusting equalizer

(Hi-fi self-adjustment)

This car stereo is equipped with a self-ad-

justing, adaptive 7-band equalizer for two	Starting the hi-fi self-adjustment
	The car stereo system must be switched on.
channels.
The left and the right channel can be ad-	• Place the microphone as required for
justed electronically for each equalizer set-	the setting you want to store.
ting.	The reading will not be correct if the micro-
	phone is held in the wrong position.

•Press / to select the setting you want to alter (EQ1, EQ2, EQ3).

To start the self-adjustment

•press ADJ and AUTO one after the other.

“MicPos5” will appear in the top line of the display, the countdown will begin. Following the countdown, the fully automat- ic self-adjustment will begin.

Hi-fi self-adjustment

You can take electronic readings and store them for three different situations, e.g.: EQ 1 for the driver alone

EQ 2 for the driver and a front-seat pas- senger

•Press DSA and EQ one after the other.

The setting selected last will appear in the top line of the display.

Noise which gradually increases in volume will be emitted from the speakers; the top line of the display will flash at the same time. Make sure that your surroundings are as quiet as possible while the reading is being taken.

86