VideoJet 8008 / VideoJet 8004 Installation and Operating Manual | EN 21 |
|
|
Data interface
The bidirectional data interface is used to control connected units, such as a dome camera with motorized lens. The range of controllable equipment is expanding constantly. The manufacturers of the relevant equipment provide specific information on installation and control.
The RS232/485 connection supports the RS232, RS422 and RS485 transmission standards. The serial interface is designed as a RJ45 socket. See page 144 for the pin assignment.
Caution
Please take note of the appropriate documentation when installing and operating the unit to be controlled. The documentation contains important safety instructions and information about permitted uses.
Note
A video connection is necessary to transmit transparent data.
Network
You can connect the unit to a 10/100/1000
– Connect the unit to the network via the 10/100/1000 MBit
Alarm inputs
VideoJet 8008 and VideoJet 8004 offer ten alarm inputs via an orange terminal block. The alarm inputs are used to connect to external alarm devices such as door contacts or sensors. When configured appropriately, an alarm device can, for example, trigger the unit to automatically establish a connection with a remote station.
A zero potential make contact or switch can be used as the actuator. You can find the pin assignment on page 146.
Note
If possible, use a
–Connect the lines to the appropriate terminals of the orange terminal block and check that the connection is secure.
Bosch Security Systems | Installation |