VideoJet 8008 / VideoJet 8004 Installation and Operating ManualEN 23
The stereo socket plugs must be connected as follows:
Contact | Audio 1 to Audio 8 | Audio Out |
Tip | Line Out | Left channel |
|
|
|
Middle ring | Line In | Right channel |
|
|
|
Lower ring | Ground | Ground |
|
|
|
–Connect the desired audio sources with line level to the Audio 1 to Audio 8 sockets with a 3.5 mm stereo plug.
–If necessary, connect two loudspeakers to the Audio Out socket.
If you wish to connect a microphone and a loudspeaker directly:
–Connect the microphone cords to the AI and ground connections on the
–Connect the loudspeaker cords to the AO and ground connections on the
Relay outputs (audio versions only)
The audio versions of VideoJet 8008 and VideoJet 8004 have five relay outputs for connecting external units such as lamps or alarm sirens. You can operate these relay outputs manually while there is an active connection to the device. The output can also be configured to automatically activate sirens or other alarm units in response to an alarm signal. The relay outputs are also located on the orange terminal block.
Caution
A maximum load of 30 V and 2 A may be applied to the relay contacts.
–Connect the lines to the appropriate R1 to R5 terminals of the orange terminal block and check that the connections are secure.
Second RS232 data interface (audio versions only)
The audio versions of VideoJet 8008 and VideoJet 8004 have a second serial interface. The RS232 connection is designed as a
Bosch Security Systems | Installation |