EN 58 | Installation and Operating Manual VideoJet 8008 / VideoJet 8004 |
|
|
The multicast address can be the same for multiple streams. However, it will be necessary to use a different port in each case so that multiple data streams are not sent simultaneously using the same port and multicast address.
Note
The settings must be made individually for each video input and, on Dual Streaming compatible units, for each stream. The numbering is the same as the labeling of the video inputs on the rear panel of the unit.
Multicast address video 1 to Multicast address video 8:
Enter a valid multicast address for each stream from the relevant encoder to be operated in multicast mode (duplication of the data streams in the network).
With the setting 0.0.0.0 the encoder for the relevant stream operates in
Note
Duplication of data places a heavy demand on the unit and can lead to impairment of the image quality under certain circumstances.
Multicast port 1 to Multicast port 8:
Assign a different port to each data stream if there are simultaneous data streams at the same multicast address.
Enter the port address of the required stream here.
Streaming:
Click the checkbox to activate multicast streaming mode for the relevant stream. The selected check boxes are marked with a tick.
Multicast packet TTL:
You can enter a value to specify how long the multicast data packets are active on the network. This value must be greater than one if multicast is to be run via a router.
Multicast address audio: (audio versions only)
For special applications, you can enter a separate multicast address for the audio data stream.
Configuration using a Web browser | Bosch Security Systems |