VideoJet 8008 / VideoJet 8004 Installation and Operating Manual | EN 27 |
|
|
–Enter i again. The terminal program displays the current IP address and prompts you to enter a new IP address.
–Enter the desired IP address and press [ENTER]. The terminal program dis- plays the new IP address.
–If necessary, enter command s and a new subnet mask.
Note
You must restart to activate the new IP address, a new subnet mask or a gateway address.
Restart
Briefly disconnect the power supply from the unit (unplug the power supply cable and plug it in again after a few seconds).
Additional parameters
You can use the terminal program to check other basic parameters and modify them where necessary. Use the
Bosch Security Systems | Installation |