EN 12
6.1.6Normal Disarming
Please read Section 7.0 Emergency Procedures on page 19 before you are confronted with an emergency event. If you entered the building through a perimeter door, you might hear a steady entry alert tone from the wired keypads. If so, disarm according to the chart below.
If an alarm occurred sometime before your arrival, one or more of these happens:
•The bells and sirens sound.
•The wired keypads issue a pulsed tone during the entry delay instead of the usual steady tone.
•The red Armed LED on any LED keypad flashes.
•The red Armed LED on any text keypad flashes and “Zone Alarm” is displayed.
If the alarm is not yet investigated, do not enter the building unless accompanied by the appropriate Emergency Services’ personnel.
Table 8: Normal Disarming
|
|
|
|
|
|
|
Equipment | Command Sequence | What Happens | What To Do | |||
|
|
|
|
|
|
|
Text Keypad LED | [PIN][Off] | • The red Armed LED turns off. | • Determine why the sounders, if |
| ||
Keypad |
| • All sounders are silenced. |
| any, were activated. |
| |
|
| • All zones are disarmed. | • | Correct the cause. |
| |
|
| • A single beep sounds. | • If a fire alarm was sounding, |
| ||
|
| • If a fire alarm was sounding, |
| correct the cause and press |
| |
|
|
| [System Reset] or [#][4][7] to |
| ||
|
|
| “Sounder Silenced” is displayed until |
|
| |
|
|
|
| reset the system. |
| |
|
|
| the system is reset. * |
|
| |
|
|
|
|
|
| |
RF3341 Keypad | [PIN][#] | • The LED flashes indicating a signal | • Determine why the sounders, if | |||
|
|
| was sent to your security system. |
| any, were activated. | |
|
| • All sounders are silenced. | • | Correct the cause. | ||
|
| • All zones are disarmed. | • If a fire alarm was sounding, | |||
|
|
|
|
| correct the cause and press | |
|
|
|
|
| [System Reset] or [#][4][7] to | |
|
|
|
|
| reset the system. | |
|
|
|
|
|
| |
RF3332/RF3332E | Press DISARM | • The LED flashes indicating a signal | • Determine why the sounders, if | |||
RF3334/RF3334E | (unlock) button |
| was sent to your security system. |
| any, were activated. | |
|
| • All sounders are silenced. | • | Correct the cause. | ||
|
| • All zones are disarmed. | • If a fire alarm was sounding, | |||
|
|
|
|
| correct the cause and press | |
|
|
|
|
| [System Reset] or [#][4][7] to | |
|
|
|
|
| reset the system. | |
* Text Keypad only | Note: When in Commercial Fire Mode, enter [PIN][#] a second time on a text or LED keypad to | |||||
| locate the fire zone number(s) in alarm. |
|
|
| ||
Bosch Security Systems 6/05 4998154961B
