Bosch Appliances DS7400XIV4-EXP manual Testing Your System, Test the system weekly Zone Test

DS7400XiV4-EXP User Guide 10.0 Testing Your System

EN 27

10.0Testing Your System

10.1Zone Test

The zone test confirms that detectors report alarms to the keypad. A zone test works on all zones, except 24-hour zones and fire zones. While the keypad is in a zone test, no control panel alarms activate an alarm, except 24-hour zone alarms and fire alarms; these alarms override the zone test function.

This test requires you to manually alarm each zone.

At the start of the test, if programmed, a report is sent to the central station followed by reports on the individual zones as they are tested. When the zone test is complete, a test restoral report is sent to the central station.

If you perform this test from a Master Keypad, the keypad must be in Single Partition Mode. Zone tests are not available from RF (wireless) keypads.

Test the system weekly.

Table 25: Zone Test

Type of Test	Command Sequence	What Happens	What To Do
Zone Test	[PIN][#][8][1]	• “Test Zone” is displayed followed by the	• Test each zone as
		numbers of the zones that were not tested. *	instructed by your
		• The zone LEDs of any untested zones flash. **	installing company.
		• “Now Testing” is displayed followed by the	• Exit the Zone Test using
		number of the zone currently being tested. *	[PIN][#].
		• The LED for the zone currently being tested
		turns on steady. **
		• As each zone is tested, “Test Zone” appears
		followed by the remaining untested zones. *
		• As each zone is tested, its LED turns off. **

*Text Keypad only ** LED Keypad only

Bosch Security Systems 6/05 4998154961B