Bosch Appliances DS7400XIV4-EXP manual En

DS7400XiV4-EXP User Guide 6.0 Day to Day Operations

EN 18

6.2.10 Changing the Date

Because you can change the system date only in Master Programming Mode, you cannot program the system date from an RF (wireless) keypad.

Record your entries so they are available before you enter Master Programming Mode. Enter the parameters promptly. If a delay of 15 seconds or more occurs between your entries, the 3-beep error tone sounds and the control panel automatically exits from the programming mode.

Table 18: Changing the Date

Steps To Change the Date	Command Sequence	If Accepted, the Text Keypad Displays:
Enter Master Programming Mode.	[Master PIN][#][0]	“2 Change Date”
		(display scrolls to this)
Enter 2 for System Date Setup	[2]	“Enter Month”
programming.		(01 ... 12)
Enter the Month.	[0][1] through [1][2]	“Enter Day”
		(01 ... 31)
Enter the Day.	[0][1] through [3][1]	“Enter Year”
		(XX) End with #
Enter the Year.	Last two digits of the year	“Month, Day, Year”
	followed by [#].	A long beep signifies acceptance.

Note: Entering the command sequence [Master Code][#][0][2][#] causes the text keypad to display the date.

6.2.11 Setting the System Clock

Because you can only set the time on the system clock in Master Programming Mode, you cannot program the system clock from an RF (wireless) keypad.

Record your entries so they are available before you enter Master Programming Mode. Enter the parameters promptly. If a delay of 15 seconds or more occurs between entries, the 3-beep error tone sounds and the control panel automatically exits from the programming mode.

Do this procedure at a text keypad because no visual clues are provided from an LED keypad.

Table 19: Setting the System Clock

Steps To Set the Time	Command Sequence	If Accepted, the Text Keypad Displays:
Enter Master Programming Mode.	[Master PIN][#][0]	“6 Change Time” *
		(display scrolls to this)
Enter 6 for System Date Setup	[6]	“Enter Day”
programming.		(1 ... 7)
Enter the Day.	[1] through [7]	“Enter Time”
	Sunday Saturday	(0100 ... 1259)
Enter the Time.	[0][1][0][0] through	“Enter AM/PM”
	[1][2][5][9]	(4/6) End with #
Enter AM or PM.	[4][#] for AM or	“Day – Time”
	[6][#] for PM	A long beep signifies acceptance.

*This is displayed only in Single Partition Mode Note: Entering the command sequence [Master Code][#][0][2][#] causes the text keypad to display the date.

Bosch Security Systems 6/05 4998154961B