6.2.6Automatic Disarming
EN 16
You can program each area to disarm automatically once per day. You cannot program automatic disarming from an RF (wireless) keypad.
If your program automatic disarming in Master Keypad mode, it affects all areas you have access to. If programmed in single area mode, or from a single area keypad, it affects only the area you are working in.
Do this procedure at a text keypad because no visual clues are provided from an LED keypad.
Table 14: Automatic Disarming
|
|
|
|
Setting the Automatic Disarming Time |
| Notes |
|
|
|
| |
[Master PIN][#][0] | You can only set the automatic disarming time in Master Programming Mode. | ||
[4] | To enter the automatic disarming setup programming. |
| |
|
|
| |
Enter the area number. | • If you are programming from a Master Keypad that is not in Single Partition | ||
Press [#] to exit. | Mode, you are prompted to enter the area to program. |
| |
| • You are allowed to program only the areas to which you are assigned. | ||
| • If you are programming from a standard keypad or from a Master Keypad in | ||
| Single Partition Mode, skip this step. |
| |
Enter a time for each day in | • Programming starts with Sunday. The keypad displays “Sunday | ||
• Enter the time in | |||
| mistake, press the [#] key twice to move back to your last entry. | ||
| • Time examples: | 12 midnight = 2400# | 12 noon = 1200# |
|
| 12:01 am = 0001# | 12:01 pm = 1201# |
|
| 1:00 am = 0100# | 1:00 pm = 1300# |
|
| Disabled = 0000# |
|
6.2.7Delayed Arming
Delayed arming causes the system to arm after a specified number of hours. Delayed arming is not available from RF (wireless) keypads. You can use delayed arming even if there are no automatic arming times programmed. If delayed arming is used in Master Keypad mode, it affects all areas you have access to. If it is used in Single Partition Mode, or from a single area keypad, it affects only the area you are working in.
Delayed arming overrides the automatic arming time. Delayed arming also provides a
Table 15: Delayed Arming
|
|
Setting Delayed Arming | Notes |
|
|
[PIN][#][9][9] | • To enter the delayed arming setup programming. |
| • The keypad displays: |
| “Arm in nn Hours |
| # to accept” |
Enter the number of hours to | Enter the number of hours from the current time that you want the system to wait before |
delay arming in [0][1] format. | arming. |
| For example, if it is 3:00pm, and you want the system to arm at 9:30pm, enter [0][6][#] |
Bosch Security Systems 6/05 4998154961B
