Bosch Appliances X10 General Malfunctions

112 en AppendixVideoJet X10

8.2	General Malfunctions
	Malfunction	Possible causes	Recommended solution
	No connection between	Incorrect cable connections.	Check all cables, plugs,
	the unit and terminal		contacts, terminals and
	program.		connections.
		The computer's serial interface	Check the other serial interface.
		is not connected.
		Interface parameters do not	If necessary select a different
		match.	interface and make sure that the
			computer's interface parameters
			match those of the unit. Try the
			following standard parameters:
			19,200 baud, 8 data bits, no
			parity, 1 stop bit. Next,
			disconnect the unit from the
			power supply and reconnect it
			again after a few seconds.
	No image transmission to	Camera error.	Connect local monitor to the
	remote station.		camera and check the camera
			function.
		Faulty cable connections.	Check all cables, plugs, contacts
			and connections.
	No connection	The unit's configuration.	Check all configuration
	established, no image		parameters.
	transmission.
		Faulty installation.	Check all cables, plugs, contacts
			and connections.
		Wrong IP address.	Check the IP addresses
			(terminal program).
		Faulty data transmission within	Check the data transmission
		the LAN.	with ping.
		The maximum number of	Wait until there is a free
		connections has been reached.	connection and then call the
			sender again.
	No audio transmission to	Hardware fault.	Check that all connected audio
	remote station.		units are operating correctly.
		Faulty cable connections.	Check all cables, plugs, contacts
			and connections.
		Incorrect configuration.	Check audio parameters on the
			Audio configuration and
			Livepage Configuration pages.
		The audio voice connection is	Wait until the connection is free
		already in use by another	and then call the sender again.
		receiver.

V3.0 2007.09 Installation and Operating Manual Bosch Security Systems