20 en Installation

VideoJet X10

 

 

4.3 Connections

4.3.1Camera

You can connect a video source to the VideoJet X10. Any cameras and other video sources that produce a standard PAL or NTSC signal are suitable.

1.Connect the camera or another video source to the BNC Video In socket using a video cable (75 Ohm, BNC plug).

2.If the video signal is not looped through, termination is performed by a software setting if necessary (see Abschnitt 5.13 Video Input, Seite 43).

4.3.2Audio Connections

The VideoJet X10 has two audio ports for audio line signals.

The audio signals are transmitted two-way and in sync with the video signals. As a result, you can connect a speaker or door intercom system at the destination point, for example. The following specifications should be complied with in all cases.

1

× Line In:

Impedance 9 kOhm typ., 5.5 Vp-pmax. input voltage

1

× Line Out:

Impedance 10 kOhm typ., 3.0 Vp-pmax. output voltage,

 

 

impedance 16 Ohm min., 1.7 Vp-pmax. output voltage

The stereo plugs must be connected as follows:

Contact

Line In function

Line Out function

 

 

 

Tip

Channel 1 (camera 1)

Channel 1 (camera 1)

 

 

 

Middle ring

–

–

 

 

 

Lower ring

Ground

Ground

 

 

 

1.Connect an audio source with line level to the Audio In socket of the VideoJet X10 with a

3.5mm stereo plug.

2.Connect a unit with line-in connection to the Audio Out socket of the VideoJet X10 with a

3.5mm stereo plug.

4.3.3Network

You can connect the VideoJet X10 to a 10/100 Base-T network using a standard UTP category 5 cable with RJ45 plugs. The second Ethernet interface can be used to create a redundant connection to the network.

i

NOTICE!

You cannot create a connection to a second network.

 

 

 

 

 

1.

Connect the VideoJet X10 to the network via the ETH 1 socket.

 

2.

Connect the VideoJet X10 to a redundant switch or hub on the same network via the

 

 

ETH 2 socket.

V3.0 2007.09

Installation and Operating Manual

Bosch Security Systems