VideoJet X10

Appendix en 119

 

 

8.8.4Assigning an IP Address

To use a VideoJet X10 in your network, you must assign it an IP address that is valid for your network.

The following default address is preset at the factory: 192.168.0.1

1.Start a terminal program such as HyperTerminal.

2.Enter the user name service. The terminal program displays the main menu.

3.Enter command 1 to open the IP menu.

4.Enter 1 again. The terminal program displays the current IP address and prompts you to enter a new IP address.

5.Enter the desired IP address and press Enter. The terminal program displays the new IP address.

6.Use the displayed commands for any additional settings which you require.

 

i

NOTICE!

 

You must reboot to activate the new IP address, a new subnet mask or a gateway address.

 

 

 

 

 

8.8.5

 

Reboot

 

 

Briefly interrupt the power supply to the VideoJet X10 for a reboot (disconnect the power

 

 

supply unit from the mains supply and switch on again after a few seconds).

8.8.6

 

Additional Parameters

 

 

You can use the terminal program to check other basic parameters and modify them where

 

 

necessary. Use the on-screen commands in the various submenus to do this.

Bosch Security Systems

Installation and Operating Manual

V3.0 2007.09