118 en AppendixVideoJet X10

8.8

Communication with Terminal Program

8.8.1

Data Terminal

 

If a VideoJet X10 cannot be found in the network or the connection to the network is

 

interrupted, you can connect a data terminal to the VideoJet X10 for initial setup and setting

 

of important parameters. The data terminal consists of a computer with a terminal program.

 

You require a serial transmission cable with a 9-pin Sub-D plug to connect to the computer

 

and open ends for connection to the terminal block of the VideoJet X10 (see Section 8.7.1 Pin

 

Assignment, page 117).

 

HyperTerminal, a communications accessory included with Microsoft Windows, can be used

 

as the terminal program.

 

 

i

NOTICE!

Information on installing and using HyperTerminal can be found in the manuals or in the online

help for MS Windows.

1.Disconnect the VideoJet X10 from the Ethernet network before working with the terminal program.

2.Connect the serial interface of the VideoJet X10 using any available serial interface on the computer.

8.8.2Configuring the Terminal

Before the terminal program can communicate with the VideoJet X10, the transmission parameters must be matched. Make the following settings for the terminal program:

–19,200 bps

–8 data bits

–No parity check

–1 stop bit

–No protocol

8.8.3Command Inputs

After the connection has been established, you must log onto the VideoJet X10 to access the main menu. Other submenus and functions can be accessed using the on-screen commands.

1.If necessary, turn off the local echo so that entered values are not repeated on the display.

2.Enter one command at a time.

3.When you have entered a value (such as an IP address), check the characters you have entered before pressing the [ENTER] key to transfer the values to the VideoJet X10.

V3.0 2007.09

Installation and Operating Manual

Bosch Security Systems