VideoJet X10 | Configuration Using a Web Browser en 79 |
|
|
5.28.7HTTPS browser port
If you wish to allow browser access on the network via a secure connection, select an HTTPS browser port from the list if necessary. The default HTTPS port is 443. Select the Off option to deactivate HTTPS ports; only unsecured connections will now be possible.
The VideoJet X10 uses the TLS 1.0 encryption protocol. You may have to activate this protocol via your browser configuration. You must also activate the protocol for the Java applications (via the Java control panel in the Windows control panel).
NOTICE!
If you want to allow only secure connections with SSL encryption, you must select the Off
i option for each of the parameters HTTP browser port, RCP+ port 1756 and Telnet support. This deactivates all unsecured connections. Connections will then only be possible via the HTTPS port.
You can activate and configure encryption of the media data (video, audio and metadata) on the Encryption page (see Section 5.30 Encryption, page 83).
5.28.8RCP+ port 1756
To exchange connection data, you can activate the unsecured RCP+ port 1756. If you want connection data to be transmitted only when encrypted, select the Off option to deactivate the port.
5.28.9Telnet support
If you want to allow only secure connections with encrypted data transmission, you must select the Off option to deactivate Telnet support. The unit will then no longer be accessible using the Telnet protocol.
5.28.10Ethernet link type 1
If necessary, select the Ethernet link type for interface ETH 1. Depending on the unit connected, it may be necessary to select a special operation type.
5.28.11Ethernet link type 2
If necessary, select the Ethernet link type for interface ETH 2. Depending on the unit connected, it may be necessary to select a special operation type.
5.28.12Network MSS (Byte)
You can set the maximum segment size for the IP packet's user data. This gives you the option to adjust the size of the data packets to the network environment and to optimize data transmission. Bear comply with the MTU value of 1,514 bytes in UDP mode.
5.28.13iSCSI MSS (Byte)
You can specify a higher MSS value for a connection to the iSCSI system than for the other data traffic via the network. The potential value depends on the network structure. A higher value is only useful if the iSCSI system is located in the same subnet as the VideoJet X10.
Bosch Security Systems | Installation and Operating Manual | V3.0 2007.09 |