VideoJet X10

Configuration Using a Web Browser en 63

 

 

5.22.4Destination password

If the remote station is password protected, enter the password here.

In this page, you can save a maximum of ten destination IP addresses and hence up to ten passwords for connecting to remote stations. If connections to more than ten remote stations are to be possible, for example when initiating connections via higher-ranking systems such as VIDOS or Bosch Video Management System, you can store a general password here. The VideoJet X10 can use this general password to connect to all remote stations protected with the same password. In this case, proceed as follows:

1.Select 10 from the Number of destination IP address list field.

2.Enter the address 0.0.0.0 in the Destination IP address field.

3.Enter your chosen password in the Destination password field.

4.Define this password as the user password for all remote stations to which a connection is to be possible.

i

NOTICE!

If you enter the destination IP address 0.0.0.0 for destination 10, the VideoJet X10 will no

 

 

longer use this address for the tenth attempt at automatic connection in the event of an

 

alarm. The parameter is then used only to save the general password.

 

 

5.22.5

Video transmission

 

If the unit is operated behind a firewall, TCP (HTTP Port) should be selected as the transfer

 

protocol. For use in a local network, select UDP.

 

 

 

CAUTION!

!

Please note that in some circumstances, a larger bandwidth must be available on the network

for additional video images in the event of an alarm, in case Multicast operation is not

possible. To enable Multicast operation, select the UDP option for the Video transmission

 

parameter here and on the Network page (see Section 5.28.5 Video transmission, page 78).

 

 

5.22.6

Remote port

 

Depending on the network configuration, select a browser port here. The ports for HTTPS

 

connections will be available only if the On option is selected in the SSL encryption

 

parameter.

5.22.7

Video output

 

If you know which unit is being used as the receiver, you can select the analog video output to

 

which the signal should be switched. If the destination unit is unknown, it is advisable to

 

select the First available option. In this case, the image is placed on the first free video

 

output. This is an output on which there is no signal. The connected monitor only displays

 

images when an alarm is triggered. If you select a particular video output and a split image is

 

set for this output on the receiver, you can also select from Decoder the decoder in the

 

receiver that is to be used to display the alarm image.

 

 

i

NOTICE!

Refer to the destination unit documentation concerning image display options and available

video outputs.

5.22.8 Decoder

Select a decoder of the receiver to display the alarm image. The decoder selected has an impact on the position of the image in a split screen. For example, you can specify via a VIP XD that the upper-right quadrant should be used to display the alarm image by selecting decoder 2.

Bosch Security Systems

Installation and Operating Manual

V3.0 2007.09