Bosch Appliances X10 SN manual Assigning an IP Address, Reboot

VideoJet X10 SN Appendix en 111

Assigning an IP Address

Before you can operate a VideoJet X10 SN in your network you must first assign it an IP address that is valid for your network.

The following default address is preset at the factory: 192.168.0.1

1.Start a terminal program such as HyperTerminal.

2.Enter the user name service. The terminal program displays the main menu.

3.Enter command 1 to open the IP menu.

4.Enter 1 again. The terminal program displays the current IP address and prompts you to enter a new IP address.

5.Enter the desired IP address and press Enter. The terminal program displays the new IP address.

6.Use the displayed commands for any additional settings you require.

i	NOTICE!
	You must reboot to activate the new IP address, a new subnet mask or a gateway IP address.

Reboot

Briefly interrupt the power supply to the VideoJet X10 SN for a reboot (disconnect the power supply unit from the mains supply and switch on again after a few seconds).

Additional Parameters

You can use the terminal program to check other basic parameters and modify them where necessary. Use the on-screen commands in the various submenus to do this.

Bosch Security Systems Installation and Operating Manual DOC V4.0 2009.06