VideoJet X10 SNConfiguration Using a Web Browser en 35
5.7 | Basic Mode: Audio |
You can set the gain of the audio signals to suit your specific requirements. The current video image is shown in the small window next to the slide controls to help you check the audio source and improve assignments. Your changes are effective immediately.
If you connect via Web browser, you must activate the audio transmission on the LIVEPAGE Functions page (see Section 5.15 Advanced Mode: LIVEPAGE Functions, page 42). For other connections, the transmission depends on the audio settings of the respective system.
Audio
The audio signals are sent in a separate data stream parallel to the video data, and so increase the network load. The audio data are encoded according to G.711 and require an additional bandwidth of approx. 80 kbps for each connection. If you do not want any audio data to be transmitted, select Off.
Line In 1
You can set the line input gain. Make sure that the display does not go beyond the green zone during modulation.
Line Out
You can set the line output gain. Make sure that the display does not go beyond the green zone during modulation.
5.8 | Basic Mode: Recording |
You can record the images from the camera connected to the VideoJet X10 SN on various local storage media or on an appropriately configured iSCSI system.
CF cards (see Section CF Slot, page 20) are the ideal solution for shorter storage times. if the VideoJet X10 SN has a USB hard drive, this is suitable for longer, local recordings. For
Here you can select a storage medium and immediately start or stop the recording.
Storage medium
1.Select the required storage medium from the list.
2.Click the Start button to start the recording immediately.
Bosch Security Systems | Installation and Operating Manual | DOC V4.0 2009.06 |
