20 en Installation | VideoJet X10 SN |
|
|
4.3Connections
Camera
You can connect a video source to the VideoJet X10 SN. Any cameras and other video sources that produce a standard PAL or NTSC signal are suitable.
1.Connect the camera or another video source to the BNC Video In socket using a video cable (75 Ohm, BNC plug).
2.If the video signal is not looped through, termination is performed by a software setting if necessary (see Section 5.17 Advanced Mode: Video Input, page 44).
Audio Connections
The VideoJet X10 SN has two audio ports for audio line signals.
The audio signals are transmitted
1 | × Line In: | Impedance 9 kOhm typ., 5.5 |
1 | × Line Out: | Impedance 10 kOhm typ., 3.0 |
|
| impedance 16 Ohm min., 1.7 |
The stereo plugs must be connected as follows:
Contact | Line In function | Line Out function |
|
|
|
Tip | Channel 1 | Channel 1 |
|
|
|
Middle ring | – | – |
|
|
|
Lower ring | Ground | Ground |
|
|
|
1.Connect an audio source with line level to the Audio In socket of the VideoJet X10 SN with a 3.5 mm stereo plug.
2.Connect a unit with
Network
You can connect the VideoJet X10 SN to a 10/100
XConnect the VideoJet X10 SN to the network via the ETH socket.
CF Slot
You can insert a type I or II CompactFlash card into the Compact Flash slot to enable recordings to be saved locally. CF cards are the ideal solution for shorter storage times and temporary recordings, for example alarm recordings or local buffering in the event of network interruptions.
NOTICE!
i You can obtain a list of compatible CF cards from your supplier or directly from Bosch Security Systems. This list is constantly being updated and extended.
Playing back recordings is also possible using a different VideoJet X10, a VideoJet X20 or a VideoJet X40.
DOC V4.0 2009.06 | Installation and Operating Manual | Bosch Security Systems |
