Bosch Appliances X20 Malfunctions with iSCSI Connections

VideoJet X20Appendix en 113

	Malfunction	Possible causes	Recommended solution
	The unit does not report	Alarm source is not selected.	Select possible alarm sources on
	an alarm.		the Alarm Sources configuration
			page.
		No alarm response specified.	Specify the desired alarm
			response on the Alarm
			Connections configuration page,
			change the IP address if
			necessary.
	Control of cameras or	The cable connection between	Check all cable connections and
	other units is not	the serial interface and the	ensure all plugs are properly
	possible.	connected unit is not correct.	fitted.
		The interface parameters do not	Make sure that the settings of all
		match those of the other unit	units involved are compatible.
		connected.
	The unit is not	Power failure during	Have the unit checked by
	operational after a	programming by firmware file.	Customer Service and replace if
	firmware upload.		necessary.
		Incorrect firmware file.	Enter the IP address of the unit
			followed by /main.htm in your
			Web browser and repeat the
			upload.
8.3	Malfunctions with iSCSI Connections
	Malfunction	Possible causes	Recommended solution
	After connecting to the	Incorrect LUN mapping during	Check the iSCSI system
	iSCSI destination, no	iSCSI system configuration.	configuration and reconnect.
	LUNs are displayed.
	After connecting to the	The LUN list could not be read,	Check the iSCSI system
	iSCSI destination, "LUN	as it was assigned to the wrong	configuration and reconnect.
	FAIL" appears below a	network interface.
	node.
	LUN mapping is not	Some iSCSI systems do not	Delete the initiator extension on
	possible.	support the use of an initiator	the iSCSI configuration page.
		extension.

Bosch Security Systems Installation and Operating Manual V3.5 2007.12