
VideoJet X20 | Configuration Using a Web Browser en 77 |
|
|
1.Make the desired changes.
2.Click the Set button.
3.Click a Reboot link to trigger a reboot. VideoJet X20 is rebooted and the changed settings are activated.
CAUTION!
! If you change the IP address, subnet mask or gateway address, the VideoJet X20 is only available under the new addresses after the reboot.
5.28.1 | IP address |
| Enter the desired IP address for the VideoJet X20. The IP address must be valid for the |
| network. |
5.28.2 | Subnet mask |
| Enter the appropriate subnet mask for the selected IP address here. |
5.28.3 | Gateway address |
| If you want the unit to establish a connection to a remote location in a different subnet, enter |
| the IP address of the gateway here. Otherwise leave the box blank (0.0.0.0). |
5.28.4 | DNS server address |
| The VideoJet X20 is easier to access if the unit is listed on a DNS server. If you wish, for |
| example, to establish an Internet connection to the VideoJet X20, it is sufficient to enter the |
| name given to the unit on the DNS server as a URL in the browser. Enter the DNS server's IP |
| address. Servers are supported for secure and dynamic DNS. |
5.28.5 | Video transmission |
| If the unit is operated behind a firewall, TCP (HTTP Port) should be selected as the transfer |
| protocol. For use in a local network, select UDP. |
CAUTION!
!Multicast operation is only possible with the UDP protocol. The TCP protocol does not support multicast connections.
The MTU value in UDP mode is 1,514 bytes.
5.28.6HTTP browser portSelect a different HTTP browser port from the list if required. The default HTTP port is 80. If you want to allow only secure connections via HTTPS, you must deactivate the HTTP port. In this case, select Off.
Bosch Security Systems | Installation and Operating Manual | V3.5 2007.12 |